• Registered: 2016-09-07
  • Posts: 15

Topic: FF802 AES/EBU output to Genelecs

Hi!
I just don't understand what I'm doing wrong.

I have two Genelec 1032C's daisy chained digitally and connected to FF802 AES/EBU output with a digital XLR cable. The Genelec GLM works nicely but shows no digital audio input.
I played music via AN 1/2 which I sent to AES. Main Out is assigned to AES and its meters show action.
I tested the cables and they are ok.

Any ideas?

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,443

Re: FF802 AES/EBU output to Genelecs

Settings dialog, AES set to 'Professional'?

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2016-09-07
  • Posts: 15

Re: FF802 AES/EBU output to Genelecs

MC wrote:

Settings dialog, AES set to 'Professional'?

Yes.
Analog audio works so the speakers are ok.  Brand new.
Something wrong in the 802 settings..

  • Jeff
  • Jeff
  • Moderator
  • Offline
  • From: USA
  • Registered: 2007-05-21
  • Posts: 4,650

Re: FF802 AES/EBU output to Genelecs

You can check the FF802 output and your cable: Connect FF802 AES out to FF802 AES in. Do you see signal in the top row of TotalMix FX, AES channel?

If not, go to Options > Reset Mix > Total Reset and try creating this Playback 1/2 to AES Out routing again.

Regards,
Jeff Petersen
Synthax Inc.

Jeff's Website

  • Registered: 2016-09-07
  • Posts: 15

Re: FF802 AES/EBU output to Genelecs

Total Reset helped! THANK YOU!!!