• Registered: 2014-02-04
  • Posts: 53

Topic: digicheck and loopback - can I still use the inputs?

hi,
I have to use the loopback of ADAT outputs 15/16 to get a signal into digicheck, because I use a Mac.

can I still use 15/16 inputs for mics, or will this be interfering with digicheck?

thanks,
jean

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,776

Re: digicheck and loopback - can I still use the inputs?

The inputs are still available in Totalmix

Regards
Daniel Fuchs
RME

RME Support's Website

  • Registered: 2014-02-04
  • Posts: 53

Re: digicheck and loopback - can I still use the inputs?

thanks, I just recorded a live session,
unfortunately the channel that was supposed to record the mics at IN 15/16 also recorded the whole loopback of OUT 15/16.

so in fact I can't use the inputs....

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: digicheck and loopback - can I still use the inputs?

Obviously. What he meant is that the inputs are still fully functional and usable in TotalMix. Route them to any unused channel and loopback over there to record them.

Regards
Matthias Carstens
RME

MC's Website