• From: Indonesia
  • Registered: 2020-06-10
  • Posts: 1

Topic: I see signals when sample rate is >96 - Fireface UFX II

I notice when I set the sample rate to anything above 96K I see some signal on all the analog imput channels on the unit and in Totalmix. I'm assuming this is noise but I don't hear anything. Is this normal?

clara_renata's Website

2 Reply by ramses (edited by ramses 2020-06-10 10:00:09)

  • ramses
  • DAW Mastermind
  • Offline
  • From: UTC+1
  • Registered: 2012-10-14
  • Posts: 12,878

Re: I see signals when sample rate is >96 - Fireface UFX II

Hi Clara. This has been asked already on forum if I remember right. Usual behaviour of the circuit if nothing is plugged in.

BR Ramses - UFX III, 12Mic, XTC, ADI-2 Pro FS R BE, RayDAT, X10SRi-F, E5-1680v4, Win10Pro22H2, Cub13
  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,705

Re: I see signals when sample rate is >96 - Fireface UFX II

There is a chapter in the manual that explains the phenomenon.


Regards
Daniel Fuchs
RME

Regards
Daniel Fuchs
RME

RME Support's Website