• Registered: 2020-08-23
  • Posts: 2

Topic: RME Babyface Pro FS - No signal in DAW for In 3/4

I just purchased this device and I'm not able to get a guitar signal into DAW (Cubase) using instrument IN 3/4. I'm able to hear what I have recorded previously into my project using my old audio interface. For the guitar plugged into IN 3/4 I only hear the direct clean signal but nothing goes through Cubase and the guitar plugin I have set for the track. So I guess Babyface is functioning correctly since I can hear audio. But how do I get the signal into Cubase? Is the routing in TotalMix the issue here? How should it be done?

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: RME Babyface Pro FS - No signal in DAW for In 3/4

Reset the I/Os in VST Devices.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2020-08-23
  • Posts: 2

Re: RME Babyface Pro FS - No signal in DAW for In 3/4

MC wrote:

Reset the I/Os in VST Devices.

I don't know if you meant VST Connections in Cubase but there I could choose Analog 3 and 4 for left and right respectively. In this section there wasn't any reset button. But anyway it's now working so thanks for the tip.