• Registered: 2020-06-12
  • Posts: 9

Topic: Logitech Harmony - mapping of IR commands mixed up

Yesterday I added a new device to my good old Harmony 900 and updated the remote.
After the update of my remote many IR commands are not correctly mapped to the command labels (buttons) any more.
I use an ADI-2 PRO FS R.

For example: "AutoDark" sends the IR command for "SD LD"

ON/OFF/Volume work correctly.

Many other buttons transmit the wrong commands.

I deleted all devices and added only the ADI-2 PRO FS - update - no change.

What can I do to solve this?
Maybe the Logitech database is corrupted?

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,851

Re: Logitech Harmony - mapping of IR commands mixed up

Are you on the latest ADI-2 Pro firmware? I think some filters were wrongly mapped before.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2020-06-12
  • Posts: 9

Re: Logitech Harmony - mapping of IR commands mixed up

V97 was installed as default and the Harmony 900 worked perfectly from the beginning until yesterday after the update.of the remote.

4 Reply by fermion (edited by fermion 2020-09-24 12:45:54)

  • Registered: 2020-06-12
  • Posts: 9

Re: Logitech Harmony - mapping of IR commands mixed up

It would be of great help if someone were able to check this. If confirmed I could be certain that this problem was caused by Logitech and not by my setup. Thanks.

5 Reply by bejoro (edited by bejoro 2020-09-26 11:24:15)

  • bejoro
  • S/Mux specialist
  • Offline
  • Registered: 2017-03-16
  • Posts: 269

Re: Logitech Harmony - mapping of IR commands mixed up

I had the same problem. It was solved with the new firmware release ADI-2 Pro: 238/98.
Unfortunately there was no thread here regarding the new FW.

I added a corresponding post to the FW notification thread.

bejoro's Website

  • Registered: 2020-06-12
  • Posts: 9

Re: Logitech Harmony - mapping of IR commands mixed up

Bernhard, Thank you very much. I was not aware of the new firmware. Obviously I updated the firmware to V97 and did not notiice the wrong behaviour, because it worked perfectly when I got the fine ADI-2 PRO FS R. It is strange, but obvious. Anyway, now with V238/98 everything is perfect again. Thank you RME.