• tmm
  • ADAT user
  • Offline
  • Registered: 2016-09-19
  • Posts: 12

Topic: Getting a surround signal from Cubase to my speakers when using a UCX?

Hi there,

I've been trying to get a 5.1 setup to work in Cubase in combination with my UCX.

In Cubase, in the Audio Connections window, I've created a 5.1 output. The left/right/center/lfe/left surround/right surround channels have been routed to the corresponding output on the UCX.

However, I'm only hearing sound that is panned left and right, routed to the Analog 1 & Analog 2 outputs.
Is there something that I should change in Totalmix FX? Iv'e got it set to DAW mode, but that did not help.

Any help would be greatly appreciated!

  • Jeff
  • Jeff
  • Moderator
  • Offline
  • From: USA
  • Registered: 2007-05-21
  • Posts: 4,650

Re: Getting a surround signal from Cubase to my speakers when using a UCX?

In DAW mode, TotalMix does not have any routing or matrix capability, so the error must some from the Cubase side. Please double check your setup there.

Regards,
Jeff Petersen
Synthax Inc.

Jeff's Website