• Registered: 2020-10-15
  • Posts: 1

Topic: Problems with stereo panning (Fireface UC, Totalmix)

Hello!
I am new to this forum.
Since I set up my new studio I experienced problems with stereo.
My problem is the following:

When I pan a channel to the right or the left side in Ableton there is now hard panning. I hear a change in the audio but not a hard panning. When I do the same in Logic Pro X the problem is also there. When I hard pan in Totalmix then there is a hard pan. So the problem must lie between the Ableton master channel and Totalmix. I updated Totalmix to the latest firmware. The problem also appears when I use the DAW mode of Total mix.
I am using a Fireface UC and a Macbook Pro. For several days I tried to solve the problem, no success. I also wrote in three Facebook groups. But no help sad I am a bit desperate. Thank you for your help!


It would be great if you don't reply RTFM, thank you!

  • Jeff
  • Jeff
  • Moderator
  • Offline
  • From: USA
  • Registered: 2007-05-21
  • Posts: 4,665

Re: Problems with stereo panning (Fireface UC, Totalmix)

In TotalMix, check the middle row (playback) channel settings for the output used in Ableton and Logic (usually AN 1/2). Click the tool/wrench icon to see the settings, and check the Width knob. Hard right is full stereo, this knob should be at 1.00.

Regards,
Jeff Petersen
Synthax Inc.

Jeff's Website