1 Topic by jbapbecker (edited by jbapbecker 2020-11-18 19:28:44)

  • Registered: 2020-11-18
  • Posts: 6

Topic: Getting crossover on all odd channels on channel 1 and all even on 2

Hi all,

As above I’m getting crossover on channel 1 from output channels 3,5,and 7, then getting crossover on 2 from 4,6 and 8.
I haven’t measured it, but at a guess I’d say the spill is only about 10db lower than the main signal.
I’m using a fireface 800. The only thing odd about my setup is still on winXP (and can’t afford to change everything quite yet)
It’s been happening since I plugged it in basically, but my brother gave me the fireface and said it worked 100% for him.

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,440

Re: Getting crossover on all odd channels on channel 1 and all even on 2

Open TotalMix, go to options, perform a Total Reset. Then open the Matrix and check that there is no unwanted routing that explains what you experience.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2020-11-18
  • Posts: 6

Re: Getting crossover on all odd channels on channel 1 and all even on 2

I'll give that a go Matthias and let you know how I get on smile

Thank you!

4 Reply by jbapbecker (edited by jbapbecker 2020-11-19 18:18:14)

  • Registered: 2020-11-18
  • Posts: 6

Re: Getting crossover on all odd channels on channel 1 and all even on 2

Hi mattius,

I tried that and unfortunately it didn’t work, however, it turned out even simpler! It was a thing called operational mode, and the choices where full or DAW. It was sitting on full (must be default) and as soon as I switched...all good. Thanks for your help