Topic: Optimal way to connect computer > ADI-2 Pro Fs > Tube amp.
Thank you for reading and providing me with some advice.
I purchased an ADI-2 Pro Fs and a tube amp for my 300ohm headphones (ZMF Verite closed back). The audio source is my computer. Currently have the computer plugged into the USB on the ADI-2, set the ADI-2 to auto mode (USB active), and then using dual TS to RCA cables to send audio from the 1/2 TS output to the tube amp RCA input.
This set up is currently working without any issues. However, I'm not sure what other settings I should be using or if this is the most optimal connection path. Before purchasing the ADI-2, I thought it would be best to use "Pass thru" mode, but no audio is sent out of the TS 1/2 connection in this mode (no audio at my tube amp). I do not need the TRS jacks in the front for any other headphones.
AD/DA Source is auto.
Ref Level for output 1/2 is Lo-Power
Auto Ref Level is ON
Width = 1.00
M/S-Proc is OFF
Crossfeed is OFF
DA Filter is SD Sharp
De-Emphasis is Auto
Course Clock is INT