• Registered: 2014-02-20
  • Posts: 8

Topic: How do you get the Digiface Dante in Switched Mode?

Howdy!


On page 7 of the 'User's Guide Digiface Dante' there's a section that says..

"The four network sockets, RJ45 format, support both 100 Mbps and 1 Gbps. The integrated LEDs show the states connected (yellow) and data traffic (green). The four ports can be used in switched (4) or redundancy (2) mode (Primary/Secondary)."

..unfortunately, there's nothing more than that, so how does one go about achieving the 4 port 'switched mode' ?


Cheers,

Damo

  • Registered: 2019-09-02
  • Posts: 23

Re: How do you get the Digiface Dante in Switched Mode?

This is controlled using Dante Controller.

Navigate to the 'Network Config' tab for the Digiface Dante in Dante controller.
Under the Dante Redundancy section you can choose between 'Switched' or 'Redundant'.

mark.cull's Website

  • Registered: 2014-02-20
  • Posts: 8

Re: How do you get the Digiface Dante in Switched Mode?

Hi Mark,

Yep... strangely enough... found the option earlier today with some assistance from the Australian Distributor.  But thanks very much for your help, I'm now good to go wink


Cheers,

D