1 Topic by Yuskey (edited by Yuskey 2021-04-09 05:06:12)

  • Registered: 2021-01-09
  • Posts: 5

Topic: Issue: "Even" mono inputs leak to output when Ext. Input is enabled

Hi, All.
I'm aware that when "Ext. Input" of Control Room Section is enabled, no inputs other than the stereo channels set in the TotalMix Fx Settings will be output to the monitor. Is this wrong?
By enabling "Ext. Input", the stereo and odd-numbered mono channels were muted as expected, but the even-numbered mono channels were not muted.
I confirmed it with the "Main" output signal of TotalMix FX and the sound actually output from the speaker.

Example:
  * External input (TM Settings)
      AN 1/2
  * Inputs
      AN 1/2 (HW), AN 1/2 (SW), AN 3/4, AN 5, AN 6, Mic 9, Mic 10
  Output when "Ext. Input" is enabled in the above settings
   => AN 1/2 (HW), AN6, Mic10

My Environment:
* OS
    Windows 10 20H2 64bit
* Driver
    TotalMix FX v1.67 and v1.72
* Device
    Fireface UFX II: SW Version 11

-------------------------------------------------------------------------------------
I have confirmed that this issue has been fixed in TotalMix FX v1.73 beta 4.
-------------------------------------------------------------------------------------

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: Issue: "Even" mono inputs leak to output when Ext. Input is enabled

Thanks for the report. Behaviour is indeed not as intended, we will look for a fix.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2021-01-09
  • Posts: 5

Re: Issue: "Even" mono inputs leak to output when Ext. Input is enabled

Matthias, thank you for your response.
I hope it will be fixed.

I also found a problem that the volume of "Speaker B" changes before and after switching snapshots, so I will post it in another thread. I would appreciate it if you could check it.