• mrl2
  • ADAT user
  • Offline
  • Registered: 2009-08-13
  • Posts: 24

Topic: Total Mix-how to add the Analog channel for headphones

Hi Folks,
I would like to have ch 1/2 play through the Analog out on my HDSPe MAdi.
I am using the interface inside of Logic 10.4.8. Not sure how to add a channel in Totalmix to achieve this, if possible. There is no Phones channel strip in my Totalmix mixer. Totalmix is set to Digital Audio Workstation Mode.
Thanks for any help. Not so good at mixers:)
Mark

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: Total Mix-how to add the Analog channel for headphones

The manual describes that Phones is in parallel to playback channel 63/64.

Regards
Matthias Carstens
RME

MC's Website

  • mrl2
  • ADAT user
  • Offline
  • Registered: 2009-08-13
  • Posts: 24

Re: Total Mix-how to add the Analog channel for headphones

Thank you.

  • Registered: 2014-12-22
  • Posts: 8

Re: Total Mix-how to add the Analog channel for headphones

A follow up question--How do I set up Total Mix fx routing to not get mic feedback when recording live in control room--I am using Adobe Audition
Thanks