• Registered: 2021-04-04
  • Posts: 70

Topic: Controlling affects for the Babyface Pro

Hi Gang:

Is there a way to assign a reverb level to the same channel input slider so that both dry and wet signal could be controlled with the same fader; thus maintaining the balance?

Thanks all over the place gang.

2 Reply by waedi (edited by waedi 2021-04-07 23:16:40)

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 4,546

Re: Controlling affects for the Babyface Pro

You can activate the Trim. In Totalmix.
There is a button T right side of the fader.
When this is pressed, the fader is no longer the output fader, it is thens omething like the input gain knob of this channel.
Changings affects all routed ways and the ratio between that signal and the effect signal keeps the same.

M1-Sequoia, Madiface Pro, Digiface USB, Babyface silver and blue
  • Registered: 2021-04-04
  • Posts: 70

Re: Controlling affects for the Babyface Pro

Thanks all over the place.