• Registered: 2020-09-05
  • Posts: 4

Topic: Significant difference in level on analog inputs

I’ve rarely have had to use stereo inputs as my ADI is an interface for protools.

Until now I need this  unit for mastering.

When running a 2 channel line input
I noticed one side is a lot lower in level. Swapped out cables, sources etc. Still the same.

I purchased it on 29th of July 2020
In the UK.  Just reading the warrant part in the manual and noticed it’s only covered for 6 months.

How do I go about getting this repaired in the UK

Really need to resolve this so I can finish up.
Thanks


Gary

2 Reply by KaiS (edited by KaiS 2021-04-26 11:00:24)

  • KaiS
  • DAW Mastermind
  • Offline
  • From: Germany
  • Registered: 2020-02-05
  • Posts: 3,153

Re: Significant difference in level on analog inputs

glwainman wrote:

I’ve rarely have had to use stereo inputs as my ADI is an interface for protools.

Until now I need this  unit for mastering.

When running a 2 channel line input
I noticed one side is a lot lower in level. Swapped out cables, sources etc. Still the same.

If you‘re talking about the ADI-2 Pro - not ADI-2 FS - under I/O / Analog Input / Settings / you find: “Trim Gain Left, Right“.

Have a look, maybe it‘s misadjusted.

KaiS's Website

  • ramses
  • DAW Mastermind
  • Offline
  • From: UTC+1
  • Registered: 2012-10-14
  • Posts: 12,116

Re: Significant difference in level on analog inputs

KaiS wrote:
glwainman wrote:

I’ve rarely have had to use stereo inputs as my ADI is an interface for protools.

Until now I need this  unit for mastering.

When running a 2 channel line input
I noticed one side is a lot lower in level. Swapped out cables, sources etc. Still the same.

If you‘re talking about the ADI-2 Pro - not ADI-2 FS - under I/O / Analog Input / Settings / you find: “Trim Gain Left, Right“.

Have a look, maybe it‘s misadjusted.

Might fit .. from old postings he seems to have ADI-2 Pro FS.

BR Ramses - UFX III, 12Mic, XTC, ADI-2 Pro FS R BE, RayDAT, X10SRi-F, E5-1680v4, Win10Pro22H2, Cub13