1 (edited by sixstrings 2021-06-18 09:27:28)

Topic: DURec-Problem; UFX+, Firmware v53, Driver v3.21

Hi,
I notice that mono recordings via the microphone inputs 9-12 (via DURec) are only played on the far left or right when playing from the USB stick. The microphone inputs are all set to mono. I also noticed the following with the UFX +: Under <Chan / mix> - <Mix to Phones Out 9/10> <Balance / Pan> is <L100>, but it cannot be corrected.
Where can you set or correct that a mono signal is also played in the stereo center?
Thank you very much! Greeting


Hallo,
Ich stelle fest, dass Mono-Aufnahmen über die Mikrofoneingänge 9-12 (via DURec) beim Abspielen vom USB Stick immer nur ganz links oder rechts ertönen. Die Mikrofoneingänge sind alle auf mono eingestellt. Ausserdem habe ich beim UFX+ folgendes festgestellt: Unter <Chan/mix> - <Mix to Phones Out 9/10> ist <Balance/Pan> auf <L100>, lässt sich aber nicht korrigieren.
Wo lässt sich das einstellen bzw. beheben, das ein Mono-Signal auch in der Stereo-Mitte abgespielt wird?
Besten Dank! Gruss

2

Re: DURec-Problem; UFX+, Firmware v53, Driver v3.21

Playback-Signal in der Input-Reihe über einen Mono-Input einspeisen, dann steht auch Pan und der Rest des Mischers zur Verfügung.

Regards
Matthias Carstens
RME