• Registered: 2021-05-28
  • Posts: 7

Topic: Babyface Pro FS mono output, two channel input

I am using a Babyface Pro FS on a Dell XPS 13 9310 notebook running Windows 10 Home.
I have a microphone connected to channel 1, and an electric guitar signal connected to channel 2.
I want to give a live streaming concert on Microsoft Teams, where the audience hears both the vocal and guitar channels in both ears. I also want to monitor my performance the same way (both instruments in both ears).
Is it possible to do this with the loopback function, and if so, how?

If not, what's the simplest piece of software that can accomplish this task?

Thanks!
Jonathan

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,436

Re: Babyface Pro FS mono output, two channel input

From the manual:

AN1→ 2. Available only in stereo mode of the AN 1/2 input pair. Copies the signal of input chan-nel 1 (Mic/Line 1) to channel 2. Typical application: A microphone should be audible on both channels of a stereo recording.

That solves your mic problem, but not the guitar. So it's Loopback then. You need to send (monitor) both input sources to hardware outputs 1/2, activate loopback, and make sure software playback 1/2 is not routed to the same output but 3/4 only. 3/4 physical out is used for monitoring.

Regards
Matthias Carstens
RME

MC's Website