• Registered: 2021-07-19
  • Posts: 3

Topic: Issues with Cubase 11 and Fireface 802.

Hi there.
I purchased the unit about 6 weeks. It has been good, but suddenly I am having issues with getting it to work with Cubase. I can see the audio signals going in when connected, and the signal is going from the main output to my monitors, but no signal is going to Cubase. I have taken screenshots, but not sure how to insert them in there - though other people who have seen them haven't noticed anything. If anyone can suggest anything that I am doing wrong within these settings, that would be great.
It has worked prior to this, so not sure what has happened.
Thanks so much.

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,436

Re: Issues with Cubase 11 and Fireface 802.

Can you play back signals from the computer (not from in to out via TotalMix)?

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2021-03-04
  • Posts: 21

Re: Issues with Cubase 11 and Fireface 802.

Check if Cubase Control Room is on or off and, eventually, its settings.

lordadb's Website

  • mkok
  • DAW Mastermind
  • Offline
  • Registered: 2020-11-04
  • Posts: 623

Re: Issues with Cubase 11 and Fireface 802.

Have you setup connections in Cubase. If you change an interface or even boot Cubase without it plugged in then it can lose routing. It may be just that nothing is assigned in connections

Babyface Pro Fs, Behringer ADA8200, win 10/11 PCs, Cubase/Wavelab, Adam A7X monitors.