1 Topic by simmsp (edited by simmsp 2017-04-26 02:50:08)

  • Registered: 2017-04-26
  • Posts: 1

Topic: Fireface 400 no volume control stand-alone

When I quit totalmix or disconnect from the computer, my Fireface 400 continues to pass through audio, but I have no control over any levels for headphones or line outputs.

The levels appear to be changing on the display, but the output level remains consistent. No matter what changes I make with the onboard control, the levels remain the same, and then when its connected to the computer again or I relaunch totalmix, it recalls the output settings in totalmix and then functions normally while connected.

Pre-amp controls still seem to respond normally.  I've never had this issue with my UFX or any other RME interfaces before.

I must be missing something.

  • Registered: 2021-09-09
  • Posts: 1

Re: Fireface 400 no volume control stand-alone

I am running into the same issue - When I'm in Standalone mode of my Fireface 400 the front panel control does nothing to the outputs, namely the Phones 7/8 output. But when I connect it back with firewire the controls work right away. Have you figured out anything? Should I log a service request somewhere? Thanks

Marcus

3 Reply by waedi (edited by waedi 2021-09-09 16:48:15)

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 4,179

Re: Fireface 400 no volume control stand-alone

Bedienungsanleitung Deutsch :
https://archiv.rme-audio.de/download/fface400_d.pdf

User manual English :
https://archiv.rme-audio.de/download/fface400_e.pdf

Above the rotary knob is a green LED, is it at CH or at LEV ?
If it is at CH push the knob for change to LEV

M1-Sequoia, Madiface Pro, Digiface USB, Babyface silver and blue