• Registered: 2019-09-01
  • Posts: 14

Topic: Constant mismatch detected

Hi Guys,


Recently I have encounterd an annoying bug. In one certain project (Logic Pro X 10.6.2), my totalmix detects a mismatch in channel and fx settings. This happens really often, from 10 seconds to 2 minutes gap. It is really annoying for my workflow, since I can't use the volume settings anymore. How can I fix this?

Catalina 10.15.7.


Thanks!

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,776

Re: Constant mismatch detected

Odd. You could try activating the option to always load Totalmix settings in the Preferences.
Are the device's driver and firmware up to date?

Regards
Daniel Fuchs
RME

RME Support's Website

  • Registered: 2019-09-01
  • Posts: 14

Re: Constant mismatch detected

Hi Daniel,



I just tried the always load Totalmix settings. But I see that it get's slow with responding sometimes. I think because the mis match was deteced (didn't get a notification though).
I got the latest driver and firmware..

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,776

Re: Constant mismatch detected

There's normally no reason for such "detection" unless the unit disconnects and reconnects. What's special about this one project that causes the issue?

Regards
Daniel Fuchs
RME

RME Support's Website

  • Registered: 2019-09-01
  • Posts: 14

Re: Constant mismatch detected

I wish I knew! In my opinion it is just a regular project like the many others is have..

6 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: Constant mismatch detected

Is that the current TM FX 1.75?

Regards
Matthias Carstens
RME

MC's Website

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 4,546

Re: Constant mismatch detected

Current Logic Pro 10.7.1 has a lot of improvements compared to your 10.6.2, give it a try.

M1-Sequoia, Madiface Pro, Digiface USB, Babyface silver and blue