1 (edited by florianro 2021-12-26 21:29:31)

Topic: TotalMix FX, Level Mismatch Solution for Neumann KH750 and ADAT

Hello,
I checked this thread regarding attenuators:
https://forum.rme-audio.de/viewtopic.php?id=25399

But I connect my KH750 via ADAT. (I use the KH80 as Monitors).

Sometimes it happened that TotalMix FX is resetting the settings to 0 line level when I start my PC (Windows 11, but it happened at well with windows 10). I normally get a warning message but last time I didn't realize that. So a few days ago I had a humming tone in my ears for about 1 hour since the speakers where starting at full level.

What do you recommend to do in this case? Is there an attenuator for ADAT? Or shall I get an xlr attenuator and switch back to XLR?
thanks,
Florian

Re: TotalMix FX, Level Mismatch Solution for Neumann KH750 and ADAT

This is one of the points in my blog article about 1st setup: https://www.tonstudio-forum.de/blog/ind … rnal-equi/

TM FX: F2 (Preferences)
Under "Device Handling"
        [x] Always init DSP devices with TotalMix FX settings

BR Ramses - UFX III, 12Mic, XTC, ADI-2 Pro FS R BE, RayDAT, X10SRi-F, E5-1680v4, Win10Pro22H2, Cub13