• Registered: 2022-01-19
  • Posts: 1

Topic: ADI-2 Pro FS r

Arrived this week . and getting into the detail

Is it possible for ADAT or SPDIF output to be set at a nominal level and be independent from the DA monitor Volume knob?

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,913

Re: ADI-2 Pro FS r

That is the default state.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2019-12-12
  • Posts: 31

Re: ADI-2 Pro FS r

MC wrote:

That is the default state.

https://www.venividivici.us/wp-content/uploads/general/fonzie_0.jpg

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,913

Re: ADI-2 Pro FS r

I might have missed a detail in the question. If you think that you could set the volume at the digital outputs then no, they alaways run 1:1. But these outputs are not influenced by the volume control, so are independent, unless the special Digital Source option has been changed to Mains.

Regards
Matthias Carstens
RME

MC's Website