• Registered: 2018-09-23
  • Posts: 24

Topic: How to avoid routing of analog input to AES Output?

Hi,
how can I avoid that the analog inputs are always routed to the AES output?
I want to do measurements with a measurement mic and playback the measurement signal.
Can not find that in the manual.

Regards
Sebastian

  • KSTR
  • AES/EBU artist
  • Offline
  • Registered: 2019-02-25
  • Posts: 106

Re: How to avoid routing of analog input to AES Output?

==> 17.4.1 USB, Class Compliant Stereo mode

  • Registered: 2018-09-23
  • Posts: 24

Re: How to avoid routing of analog input to AES Output?

Hi if I understand it right - the Analog Inputs are not routed to AES if the USB Mode is active - ok.
My problem was that during the setup of the measurement system - the computer is not connected - and suddenly the Inputs are routed to the output and I get feedback problems. How to avoid that then?
There must be a way to be sure that regardless what happens there is no analog signal routed to the output.

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,913

Re: How to avoid routing of analog input to AES Output?

You simply select USB mode instead of Auto...

Regards
Matthias Carstens
RME

MC's Website