1 Topic by JCorbett (edited by JCorbett 2022-01-27 20:41:56)

  • Registered: 2022-01-27
  • Posts: 2

Topic: Fireface UC: Duplicating output for a subwoofer?

Is there a way in TotalMix to have my stereo mix duplicated to another, either stereo pair or mono out, to go into a subwoofer for a 2.1 setup?

Thanks!

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,435

Re: Fireface UC: Duplicating output for a subwoofer?

Of course. Manual chapter 28.3, Doubling the Output Signal (Mirror).

Regards
Matthias Carstens
RME

MC's Website

3 Reply by JCorbett (edited by JCorbett 2022-01-30 16:04:29)

  • Registered: 2022-01-27
  • Posts: 2

Re: Fireface UC: Duplicating output for a subwoofer?

MC wrote:

Of course. Manual chapter 28.3, Doubling the Output Signal (Mirror).


28.3 Doubling the Output Signal (Mirror)
If a mix should be sent out via two (or more) different hardware outputs simply mirror that mix to
any number of other outputs. A right click on the original output brings up the option to
Copy/Mirror <name>. Another right click on the new output, then selecting Mirror of Output
<name> will paste the whole submix and then synchronize it automatically to any future
changes. The outputs now always send out the same signals, but their main volume (faders)
stay fully independent.

Is there a way to link the faders?

EDIT: Of course there is. All done, thanks!