1 Topic by snoskit (edited by snoskit 2022-03-25 13:30:51)

  • From: UK/CH
  • Registered: 2018-08-18
  • Posts: 43

Topic: Matrix Setup for 9632 + ADI-2

Hello

I thought I understood TotalMix Matrix, but no ...

I have a 9632 fitted with a AI4S-192 AIO and connected to an ADI-2 via ADAT cables.

I can't seem to work out how to setip the matrix up to my needs.

I want the ADI-2 on ADAT 1/2 to become the master out, with all inputs and play back channels summing to it.

The settings are:
https://i.ibb.co/kcB2GKK/9632-config.jpg

I get get all channel out of the ADI-2 with this matrix setup, but the AES seems the 'master' channel, which is confusing me.
https://i.ibb.co/S0cYx4p/9632-MATRIX2.jpg

Mixer:
https://i.ibb.co/0Q05VLZ/9632-Mixer2.jpg

I'd me very grateful if someone could tell me where I'm going wrong.

Thanks.

ps

Driver v4.26

HDSPe AES + HDSPe RayDat + HDSPe MADI
ADI-2 mk.1 x2 + other converters
Cubase + VEP
  • Registered: 2021-12-30
  • Posts: 151

Re: Matrix Setup for 9632 + ADI-2

Hi there smile

What do you have assigned as your Main Out in the control section? One of the things about Totalmix that tripped me up initially was me not knowing that when you click the Assign button and select whichever channel you want for Main Out or Phones, that channel then "disappears" from the output row. This is because the Main or Phones slider becomes that channel. If you click on the Names button in the blue Routing Mode box, you can toggle between the actual input/output names and you'll see Main and Phones switch to whatever is currently assigned.

I'm not an expert at the matrix so I'm not sure I can be much help interpreting it. Just try clicking on each of the outputs that are seeing signal in the mixer and pay attention to where the levels are coming from. I'm sure you'll be able to figure it out.

-Steve