• Registered: 2022-03-28
  • Posts: 4

Topic: [Solved] Ableton doesn't recognize the 7 and 8 input of my ufx2

Total mix is showing and playing the signal i send threw 7 and 8 both configured as mono channels. It happened in the middle of a session. Suddenly there was no signal shown in ableton on these two channels.  I got win ableton 11 everything updated interface connected via usb. I am thankfull for any idea.

Greetings my first post here

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,690

Re: [Solved] Ableton doesn't recognize the 7 and 8 input of my ufx2

Does this work with other software (Reaper etc.)?

Regards
Daniel Fuchs
RME

RME Support's Website

  • Registered: 2022-03-28
  • Posts: 4

Re: [Solved] Ableton doesn't recognize the 7 and 8 input of my ufx2

RME Support wrote:

Does this work with other software (Reaper etc.)?

Will try dat later with a free daw i can find. Or pro tools if i got it installed.

  • ramses
  • DAW Mastermind
  • Offline
  • From: UTC+1
  • Registered: 2012-10-14
  • Posts: 12,863

Re: [Solved] Ableton doesn't recognize the 7 and 8 input of my ufx2

Reaper is easy to install and deinstall.
The installation of protools might have more impact to your system.

BR Ramses - UFX III, 12Mic, XTC, ADI-2 Pro FS R BE, RayDAT, X10SRi-F, E5-1680v4, Win10Pro22H2, Cub13
  • Registered: 2022-03-28
  • Posts: 4

Re: [Solved] Ableton doesn't recognize the 7 and 8 input of my ufx2

RME Support wrote:

Does this work with other software (Reaper etc.)?


Same problrm in reaper all otjer tracks are working. Same like in ableton.

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,690

Re: [Solved] Ableton doesn't recognize the 7 and 8 input of my ufx2

Have you got Loopback activated for outputs 7/8?

Regards
Daniel Fuchs
RME

RME Support's Website

  • Registered: 2022-03-28
  • Posts: 4

Re: [Solved] Ableton doesn't recognize the 7 and 8 input of my ufx2

Omfg that was it. Shit haha my friends where sampling something in a session and i didnt think about it even if i was standing next to them. Didnt know that behavior cause i never used loopback for that channels. Thanks a lot.

RME Support wrote:

Have you got Loopback activated for outputs 7/8?