You are not logged in. Please login or register.
RME User Forum → FireWire & USB series → Turn on 48V phantom power via Babyface Pro
Hi, I cannot seem to turn the Babyface pro, phantom power, on and off using the select switch. I read in the manual that I needed to select the channel (I did and it is blinking orange- channel 1). And nothing. I can turn it on in the totalmix software but I cannot do it from the interface itself. Yes, I updated to the latest firmware as well. At least I think it is v129
If I remember this correctly the button must be pressed for a while, one or two seconds or so, not just click.
I did hold it for a bit. I have tried A set and B set and nothing is working.
Hello!
When the BF Pro is connected to a PC or Mac, you can turn Phantom power, On, only in TMFX!
The key combination described in the manual is for Stand-alone Mode, only!
Guys. I found a Solution.
Go to your TotalMix, Click Options on top left tab, Click ARC& Key Commands
There we will have the shortcut keys for the 3 mappable buttons.
You set anything you want for those 3 mappable buttons
But i set my button A in Remote Controller to Phantom 1 - and the type is Toggle. So i can switch on and off with 1 press
Save it and voila. There you go!!!
Here is an image of my settings
Aah! Very nice!
Thanks!
RME User Forum → FireWire & USB series → Turn on 48V phantom power via Babyface Pro
Powered by PunBB, supported by Informer Technologies, Inc.