Topic: TotalMix FX Remote (iPad) not following faders

Have my iPad connected to my DAW (DigiFace USB) and while I can see peak/RMS meter changes in real-time, the routing and the faders are not following the Windows TotalMix FX settings.

For example, I ran a 1kHz tone generator into ADAT 1, and can see the level in real-time on the iPad, but the fader, which is set to nominal (0) on the Windows TotalMix FX UI, shows as infinity (bottom) on the iPad.

Also, the routing assignments (using "Free") don't reflect what's set on the Windows UI in the iPad, so it's basically useless except passive viewing.

2

Re: TotalMix FX Remote (iPad) not following faders

Your WiFi connection seems to be one way only. So either the settings are not correct or Windows Firewall blocks it.

Regards
Matthias Carstens
RME

Re: TotalMix FX Remote (iPad) not following faders

MC wrote:

Your WiFi connection seems to be one way only. So either the settings are not correct or Windows Firewall blocks it.

Windows Firewall is disabled on the host DAW, and if it was one-way only, why can I see the meters change on the iPad?