• Registered: 2015-06-09
  • Posts: 25

Topic: UFX word clock termination

I have a Fireface UFX (original) and I have managed to destroy the internal word clock termination push switch; only the base is left. Of course, this means that the push switch no longer works.

Luckily, the switch is stuck in the "off" (not terminated) position. This is fine when I use the UFX connected to my OctaMic II.

However, when I use the UFX "solo", I would like to terminate word clock. Can I accomplish this by attaching a 75 Ohm BNC plug to the word clock BNC OUT connector on the back of the UFX?

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,433

Re: UFX word clock termination

No. It's in the manual: T-connector with 75 Ohm terminator on the input BNC.

Regards
Matthias Carstens
RME

MC's Website