1 Topic by drsoundphd (edited by drsoundphd 2023-07-03 20:17:44)

  • Registered: 2023-07-03
  • Posts: 2

Topic: UFX II Snapshots (tmss) won't load in Total Mix with UFX III connected

My Fireface UFX II just had a power supply failure and I had to buy a UFX III as a replacement. I run my entire studio monitoring options off of recallable snapshots -- all of which were saved using the former UFX II interface. I spent hours setting that up but now when I try to open those same .tmss snapshots in Total Mix with the new UFX III connected, NONE of them will load. I get an error that says "Mismatch detected - Snapshot File contains no data for the connected Device."

QUESTIONS:
Is there anyway to edit these snapshot files to support the UFX III connection?

Is there anyway to update the tmss snapshot files to be read by the UFX III interface?

Please help!
Thanks!

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: UFX II Snapshots (tmss) won't load in Total Mix with UFX III connected

Not sure that is possible (as the UFX III has tons more mixer knots and channels), but we'll check.

Regards
Matthias Carstens
RME

MC's Website

3 Reply by drsoundphd (edited by drsoundphd 2023-07-04 02:20:31)

  • Registered: 2023-07-03
  • Posts: 2

Re: UFX II Snapshots (tmss) won't load in Total Mix with UFX III connected

Ok I figured that might be the issue but thank you for checking and hopefully there is a solution still. 
Thanks!

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: UFX II Snapshots (tmss) won't load in Total Mix with UFX III connected

It turned out that under the hood both units use a different mixer design which makes those snapshots incompatible. So it needs a special converter feature in TM FX, but this will not be added quickly (if at all).

Regards
Matthias Carstens
RME

MC's Website