1 Topic by jpboisbriand (edited by jpboisbriand 2023-08-19 18:24:00)

  • Registered: 2016-03-22
  • Posts: 4

Topic: REW calibration file into ADI-2 DAC fs or Pro w the new ADI-2 Remote?

Is there a way to import a REW calibration file into ADI-2 DAC fs or Pro? By software conversion or by editing a txt file or something and import it back into the device? Or maybe with other softwares like Sonarworks Reference 4/ID by exemple.

Thanks!

2 Reply by KaiS (edited by KaiS 2023-08-19 23:37:34)

  • KaiS
  • DAW Mastermind
  • Offline
  • From: Germany
  • Registered: 2020-02-05
  • Posts: 3,525

Re: REW calibration file into ADI-2 DAC fs or Pro w the new ADI-2 Remote?

Read the following in the light that I don’t use REW:

I assume you want to load REW generated EQ curves for speaker/room correction into ADI-2.


Currently there’s no software interfacing for this, but maybe in near future.
With the ADI-2 Remote app, it’s already possible to load PEQ settings into ADI-2.
REW just would need to include ADI-2 in it’s existing list of various file formats.
@MC: maybe contact REW about this.


Meanwhile, as REW can deliver PEQ settings, the interfacing “dial the values in manually” exists, directly on the device or within the Remote app.

Here’s a “how to”:
https://mehlau.net/audio/room-correction-peq/index.html

At the end of the page you find an REW generated example PEQ that can be dialed into ADI-2 manually:
https://mehlau.net/audio/room-correctio … ilters.png

KaiS's Website

  • Registered: 2019-06-19
  • Posts: 16

Re: REW calibration file into ADI-2 DAC fs or Pro w the new ADI-2 Remote?

I communicated with rew on this issue and the answer is no support is planned.  I use rew a lot to set up eq on adi-2.  There are only 5 filters available so it's not an issue to enter them manually. Turn on dual eq on adi2 so that you can set up l and r outputs from rew. Also after setup, run the rew sweep again to check result often some adjustments required.
Cheers