• From: Norway
  • Registered: 2007-05-02
  • Posts: 7

Topic: ADI-2 Digital pass-through, how to turn it on?

As my ADI-2 is currently serving as a DA only, I had a quick read of the manual and found this:

"The button INPUT LEVEL offers a fourth state (LEDs off), digital pass-through mode with analog monitoring (DA-converter). In this mode the AD-converter is not used. The level meters show the audio level of the digital input signal."

I am, however, unable to turn this feature on, am I missing something obvious? The input button only cycles between the three levels, not a fourth "all leds off" setting.

Thanks,
j,

--
HDSPe AES/Babyface/Adi-2

Transistor's Website

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,823

Re: ADI-2 Digital pass-through, how to turn it on?

You have an older unit without this feature. The manual that you read (most probably from our website) describes a newer unit (after 2006).

Regards
Matthias Carstens
RME

MC's Website

  • From: Norway
  • Registered: 2007-05-02
  • Posts: 7

Re: ADI-2 Digital pass-through, how to turn it on?

Ah. That explains it.

Thanks,
j,

--
HDSPe AES/Babyface/Adi-2

Transistor's Website