• Registered: 2023-10-17
  • Posts: 17

Topic: Interaction of Loudness, B/T, and PEQ

It’s clear that the Bass/Treble and PEQ “stack” and I’m guessing loudness does too? So if I have Bass/Treble and PEQ set up such that I have a bass shelf of +6 (combined) and Loudness fully engaged (volume below the minimum level for Loudness) with another +7 boost, would I then have +13?

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,586

Re: Interaction of Loudness, B/T, and PEQ

Yes.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2023-10-17
  • Posts: 17

Re: Interaction of Loudness, B/T, and PEQ

Thanks, does the ADI-2 DAC then do some pre-amp gain calculations automatically based on the stack of all these modifiers to prevent clipping?

4 Reply by KaiS (edited by KaiS 2023-11-22 01:05:18)

  • KaiS
  • DAW Mastermind
  • Offline
  • From: Germany
  • Registered: 2020-02-05
  • Posts: 3,525

Re: Interaction of Loudness, B/T, and PEQ

antagron wrote:

Thanks, does the ADI-2 DAC then do some pre-amp gain calculations automatically based on the stack of all these modifiers to prevent clipping?

“Auto Ref Level” function does prevent clipping in all cases.

But anyway - Loudness‘ boost becomes active way below full volume only, where clipping is impossible.

KaiS's Website