Hello, everyone.

Using TotalMix v 1.85

I create a Fader Group for my Mix 1 Snapshot, and it is for an AES output (midfield monitors), as well as AN 3/4 output (subwoofer). When I create them, I actually have the gain of the sub a bit higher than my monitors, and it works fine. I store the snapshot on Mix 1, and all is well. The gains move relative to each other where I had them.

If I then use the Arc USB and switch to Snapshot 2/Mix 2, for example, then switch back to Snapshot/Mix 1, the Fader Group is still there, but the gains are now both equal to each other, starting at 0, and they move relative to each other, always being at the same level.

I'm not sure why this is happening, but this is my current dilemma. Please see this video that shows it happening. I will start on Mix 1, the gains move relative to each other, being at different levels, switch to Mix 2, then I switch back to Mix 1, and the Fader Group now shows equal levels at 0.

https://drive.google.com/file/d/1TwYL5i … sp=sharing