• Registered: 2019-06-25
  • Posts: 25

Topic: Bug in EQ type of band 3 TotalMix FX UFX+ OSC

TMFX v 1.93 MacOS (3)
RME Thunderbolt Settings Firmware: v112, Driver: v1.05
Fireface UFX+ (23919669) (the old hardware version, I guess: SW Version: 55, Active Nodes: 105
Mac OSX 12.7.2 (Monterey)

OSC from and to the type of band 3 of the EQ

value  type
0     bell
0.5   shelving
1.    high pass
1.5   low pass

This should be

value         type
0             bell
0.333333      shelving
0.666667      high pass
1             low pass

This works in band 1 of the EQ.

This bug is serious, since it prevents programming presets outside of TotalMix FX.
I have not checked if this can be overcome with some external MIDI control, but that would be a hack...

I've already posted two other bug reports, and have not received any confirmation from anyone from RME.
Since I can't find any other way to submit bug reports on the RME website, I would at least ask for a confirmation that the post is read and the bug will be tracked (or is already known, etc.) by someone from RME.
The reason I buy products made by RME is their long term support for interfaces.
Responding to bug reports should be part of that.
So, I hope someone from RME will read my bug reports and will be so kind to send a reply.

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,582

Re: Bug in EQ type of band 3 TotalMix FX UFX+ OSC

There are holidays, fairs and audio shows, and people travelling...

We are very thankful for the 5 reports, but you can't expect us to immediately work on them. Give us a few days...

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2019-06-25
  • Posts: 25

Re: Bug in EQ type of band 3 TotalMix FX UFX+ OSC

Thanks for the reply! I did not know that. Good luck!