• Registered: 2021-12-18
  • Posts: 30

Topic: Why does the volume reset?

Hi.

When I restart my computer, the Master mix, starts from all the way up maxed volume, and I do the mistake to open something and it plays at highest loudness until I turn it up. A bit annoyed by this, is there a way to set a default start-up volume? So if I plug the interface in/out, or restart my pc, it won't cause the sudden very high sound.

Thanks.

2 Reply by ramses (edited by ramses 2024-02-16 21:25:29)

  • ramses
  • DAW Mastermind
  • Offline
  • From: UTC+1
  • Registered: 2012-10-14
  • Posts: 13,183

Re: Why does the volume reset?

Store the desired volume in TM FX in a snapshot and configure in Preferences:

1. Snapshots: Do not load "--"
2. [x] Always init DSP devices with TotalMix settings

You need to solve your level mismatch.
0 dBFS is simply 0 dBFS and not a volume level at all…
If it "hurts" at 0 dB, then your setup is suboptimal in terms of level mismatch.

Regarding Level mismatches and solutions, see this interesting article of Matthias Carstens (RME):
https://forum.rme-audio.de/viewtopic.php?id=25399

I also offered a few suggestions here and there in the forum, e.g.:
https://forum.rme-audio.de/viewtopic.ph … 49#p206449

BR Ramses - UFX III, 12Mic, XTC, ADI-2 Pro FS R BE, RayDAT, X10SRi-F, E5-1680v4, Win10Pro22H2, Cub14
  • Registered: 2021-12-18
  • Posts: 30

Re: Why does the volume reset?

Thank you very much.

ramses wrote:

Store the desired volume in TM FX in a snapshot and configure in Preferences:

1. Snapshots: Do not load "--"
2. [x] Always init DSP devices with TotalMix settings

You need to solve your level mismatch.
0dBFS is simply 0dBFS and not a volume level at all…
If it "hurts" at 0 dB, then your setup is suboptimal.

Regarding Level mismatches and solutions see this interesting article of Matthias Carstens (RME):
https://forum.rme-audio.de/viewtopic.php?id=25399

I also offered a few suggestions here and there in the forum, e.g.:
https://forum.rme-audio.de/viewtopic.ph … 49#p206449