Topic: RME Digiface USB Toslink output channel
I'm a new user of Digiface USB and use it as multiple toslink output device.
When it works as toslink output it's a bit inconvenient because I need to route the channel again when using different sampling rate due to the channel change.
For 44.1/48kHz sampling rate I'll need to use ADAT 1/2 for toslink out 1, ADAT 9/10 for toslink 2 and so on.
But for 88.2/96kHz it'll become ADAT 1/2 for 1st output, ADAT5/6 for 2nd output, ADAT 9/10 for 3rd output
And 176.4/192kHz would be ADAT 1/2 for 1st output, ADAT 3/4 for 2nd output.
This kind of order change makes the device hard to use at different sampling rate.
Is it possible to set SPDIF out for ADAT 1/2, 3/4, 5/6, 7/8 and map it to 1st, 2nd, 3rd, and 4th toslink output no matter what sampling rate I'm using?
Thank you very much.