When using the front panel to change the gain on mic 1&2 and ensuring to use the setting for changing both mic1&2, if I turn the encoder slowly the mic 2 changes in increments of 2 while mic 1 changes in increments of 1. If I move the encoder faster then it often results in the same level +/-1. I have tried with AS on and off, but it does the same.

I am new to RME interfaces, and have not finished reading the manual, however I see no mention of this behavior in the relevant section. Is this expected behavior? It does not seem right to me. Maybe the encoder has an issue, but surely this would be a software issue as the encoder would only send a single value?

Any insight would be useful.