• Registered: 2024-05-01
  • Posts: 1

Topic: Loopback in Standalone mode

I need explanation regarding loopback function and I don't know is this possible at all.

This is the case. Input signal (mic) on a channel 1 I want to send to ADAT output (and that is not a problem). Then I want to activate loopback and send that signal to ADAT input. 

So, my question is, can I on my phones output (and I'm asking this because I wasn't able to do this) or any other output (except ADAT) monitor mix of channel 1 and that ADAT input without DAW. This is because I want to use my UCX II as standalone mixer without any DAW. And I would like to doubling the inputs with the same signal and different processing on each of them.

So far I have not succeeded.

Please explain.
Thanks

2 Reply by waedi (edited by waedi 2024-05-01 20:26:36)

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 4,525

Re: Loopback in Standalone mode

Loopback function does not loop back the signal into Totalmix, it forwards the signal to an input channel, available for a DAW.
You have to use cable loopback, cable from an output to an input. Just be careful to prevent feedback.

M1-Sequoia, Madiface Pro, Digiface USB, Babyface silver and blue