• Registered: 2016-03-24
  • Posts: 22

Topic: Volume limiters

I’m using RME UFX as the centrepiece of an active speaker setup. One concern that I’ve got is that a problem with the USB attached computer overdrives and damages speaker drivers. Is it possible, in Total Mix, to limit the maximum output signal on each of the analogue outputs?

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 4,533

Re: Volume limiters

Active speakers should be built with internal limiters or protection.
You have to control the output manually, lower the fader to -10 or so.

M1-Sequoia, Madiface Pro, Digiface USB, Babyface silver and blue
  • Registered: 2016-03-24
  • Posts: 22

Re: Volume limiters

waedi wrote:

Active speakers should be built with internal limiters or protection.
You have to control the output manually, lower the fader to -10 or so.

The impact of lowering the fader is to just reduce the gain applied to the input signal. I’m hoping to set a limit on the output volume irrespective of the input signal. Is this possible?

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 4,533

Re: Volume limiters

I'm afraid, no.

M1-Sequoia, Madiface Pro, Digiface USB, Babyface silver and blue
  • Registered: 2018-12-21
  • Posts: 322

Re: Volume limiters

Not a limiter, but maybe consider using attenuators:
https://forum.rme-audio.de/viewtopic.php?id=25399

  • Registered: 2016-03-24
  • Posts: 22

Re: Volume limiters

waedi wrote:

I'm afraid, no.

Thanks

  • Registered: 2016-03-24
  • Posts: 22

Re: Volume limiters

hselters wrote:

Not a limiter, but maybe consider using attenuators:
https://forum.rme-audio.de/viewtopic.php?id=25399

Yes, not quite the solution that I am after but a very helpful link nonetheless. Thanks.