• Registered: 2022-05-17
  • Posts: 2

Topic: Babyface Pro wit ADAT - Midi and/or Volume dial remapping

Hi all together,

I use the Babyface Pro with an additional ADAT device.
With the dial, I can use Adat AS1/AS2 for the volume (Opt). But I want to use the dial for Adat 3/4. I could not configure it, and I'm unable to map Hardware Outputs to an external Midi device (Korg nanokontrol 2).

Would it be possible to map Adat 3/4 (or any other output) to the Volume dial of the Babyface or map hardware outputs via Midi in general, or not?

I use
- Sonoma latest version
- TotalMix 1.95
- Firmware 206
- Driver 4.10


Thanks
Andreas

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: Babyface Pro wit ADAT - Midi and/or Volume dial remapping

The dial is hardware-coupled so not reconfigurable. You could link 1/2 with 3/4 if that makes sense in your application.

MIDI control of ADAT 3/4 via TM FX should work as explained in the manual,  chapter 24.5,  MIDI control.

Regards
Matthias Carstens
RME

MC's Website