• Registered: 2020-08-04
  • Posts: 17

Topic: Rme Dps-2

I have purchased the DPS-2 and am using it along with the ADI2 pro fs r BE.

I have a novice question on the power cable connecting the DPS-2 with the ADi2. On the DPS-2 side it says that a Kycon locking plug is used. Is there any particular way in which to unplug this Kycon locking plug or should I just pull it out? Is there any particular way to lock the plug in place - I just pushed it in as much as it would go.

  • Registered: 2020-08-04
  • Posts: 17

Re: Rme Dps-2

Please can you confirm again that the Kycon 4pp locking plug on the DPS-2 should be pushed in and turned for both plugging and unplugging. I checked in my unit and it does not look like the plug can be rotated.

3 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,582

Re: Rme Dps-2

The connector has a big arrow on top to show that you have to move/slide the outer shelll, then can pull the connector out. No turning. If you grab the moveable shell then unplugging is by pulling the connector out. It's not easy, though, some force needed.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2020-08-04
  • Posts: 17

Re: Rme Dps-2

MC wrote:

The connector has a big arrow on top to show that you have to move/slide the outer shelll, then can pull the connector out. No turning. If you grab the moveable shell then unplugging is by pulling the connector out. It's not easy, though, some force needed.

Thank you, that is very clear.