1 (edited by johanh211 2024-08-19 07:14:35)

Topic: SOLVED: Is this routing correct for ADAT Out? Settings attached..

Hi there!

System: UFX II

I am stuck routing a signal from Ableton to my Expert Sleepers ES-3 via an optical cable

I see the outgoing signal in green and active in the designated ADAT hardware output in Total Mix routing from Ableton.
But there is no signal.

I have checked the optical cable and the ES-3 module and when I rout a hardware synth signal through a ferrodish convertor it does pass through to the ES-3.

So something goes wrong in the RME (software) settings..

Please see the link for my Total mix setting

Many thanks for your help!

https://imgur.com/a/Lv5fRl5

Re: SOLVED: Is this routing correct for ADAT Out? Settings attached..

Yes, routing seems correct. Have you by chance set the optical output to spdif instead of adat, in the fireface settings app that is separate from Totalmix? Or simply plugging the cable mistakenly to adat out 2 insted of 1?

May seem obvious, but better to check anyway. wink

Fireface UFX+ | Fireface UFX | Babyface Pro | 12Mic

Re: SOLVED: Is this routing correct for ADAT Out? Settings attached..

"Have you by chance set the optical output to spdif instead of adat"

This was the culprit :x

Thank you so much for taking the time to read my post and help out!!

Bless you!