1 Topic by johnnysh (edited by johnnysh 2024-11-13 00:50:01)

  • From: London
  • Registered: 2015-11-07
  • Posts: 45

Topic: UFX III Strange Level On Inputs LEDS Flickering

Hello

I am the proud owner of a new UFXIII to replace my UCX

So far very happy with unit, but i am seeing in total FX flickering LEDs flashing on the first scale of the faders and on the front panel Display for all the analogue channels

the levels are reading -68/70 db respectively for each analogue channel

yet still VU leds are flashing between on and 1st bar ??

I have even unplugged audio cables from various equipment and still have this issue ??/

Is this to be expected??

with the audio equipment turned off or even the RCAs cables unplugged why am I seeing Leds for the Analogue inputs flashing

Thanks

Never Give Up In Striving For Perfection

2 Reply by waedi (edited by waedi 2024-11-13 04:41:09)

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 4,539

Re: UFX III Strange Level On Inputs LEDS Flickering

In Totalmix in the input channels are all gain knobs closed ?
Are there any input level settings ? Make them off.
With open gain a little flickering in the micro-area can happen but not flashing LEDs.
Please check from above and disconnect all audio-cables,
if the input LEDs still flashing provide a video and screenshots of the Totalmix input channels

M1-Sequoia, Madiface Pro, Digiface USB, Babyface silver and blue

3 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: UFX III Strange Level On Inputs LEDS Flickering

Your sample rate is 192 kHz - see manual, 40.6 Noise level in DS / QS Mode. Plus set level meters to show RMS.

Regards
Matthias Carstens
RME

MC's Website