1 Topic by Redcliff (edited by Redcliff 2024-12-12 08:43:19)

  • Registered: 2023-01-11
  • Posts: 20

Topic: MADI HDSPe FX card FPGA version question

My card is pretty old and shows to be the following:

SN=23589544
Revision=92

I did locate a thread that I mentioned enhanced FPGA capabilities in the Totalmix FX section forum.

https://forum.rme-audio.de/viewtopic.php?id=39428

It states that the FPGA revision of a MADI HDSPe FX card revision needs to be above 200 to accommodate the Room EQ. Since mine says Revision=92, I'm assuming that although it doesn't mention FPGA, the numeral 92 must refer to the FPGA revision because there is no Room EQ factory preset after updating to the most recent firmware and driver v2.6. If I'm mistaken about this somehow, please reply. If not I'll leave this here for now in case someone else has the same question.

MADIFX, M-32AD M-32DA, M-16DA, ADI-8QSM x 2, ADI-648, ADI 192 DD, ADI-2,  MadiFace Pro
  • From: Haimhausen
  • Registered: 2012-04-02
  • Posts: 271

Re: MADI HDSPe FX card FPGA version question

Correct. Indeed you have a version 1 MADI FX with no Room EQ possibilities.

Regards,
Audio AG Support

Audio AG Support's Website

3 Reply by Redcliff (edited by Redcliff 2024-12-12 13:35:11)

  • Registered: 2023-01-11
  • Posts: 20

Re: MADI HDSPe FX card FPGA version question

Audio AG Support wrote:

Correct. Indeed you have a version 1 MADI FX with no Room EQ possibilities.

Thanks,

As I suspected. I purchased this card sometime around 2013. I'm curious. When were the v2 cards created?

MADIFX, M-32AD M-32DA, M-16DA, ADI-8QSM x 2, ADI-648, ADI 192 DD, ADI-2,  MadiFace Pro