• pg13
  • pg13
  • New member
  • Offline
  • Registered: 2025-01-15
  • Posts: 2

Topic: Mac Digicheck NG 0.91 Setup issue

Hi there,

RME newbie here so please excuse me if I'm missing the seemingly obvious^^

I'm using a Madiface Pro interface (Firmware v69, Driver v4.17) on Apple MBP M1 Pro chip running Monterey v12.7.6.

I have the Analog 1/2 assigned to the main outs in TotalMix plugged into my active monitors.
When I active the Loopback function on on the Main Section I get signal coming in Digicheck - no problem there.

But I don't want it to analyze my monitor outputs - because it's for my monitors (duh!), the levels are usually low and constantly changing - I want it to analyze my Software playback stereo outputs setup at constant nominal 0.00dB.

I wish I could change which outputs Digicheck analyzes, but I can't select any other source in Audio Device Setup.

How can I achieve this?

Thanks for your help

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,852

Re: Mac Digicheck NG 0.91 Setup issue

You don't select inputs in the Audio Device Setup, but in the context menu of each single instrument - Input Selection - where you will see all 68 input channels and all 68 playback channels....

Regards
Matthias Carstens
RME

MC's Website

  • pg13
  • pg13
  • New member
  • Offline
  • Registered: 2025-01-15
  • Posts: 2

Re: Mac Digicheck NG 0.91 Setup issue

Thank you MC!
Simple - that's what I was looking for:)
Problem solved.