• edg
  • New member
  • Offline
  • Registered: 2009-10-30
  • Posts: 1

Topic: Digicheck 0.61: help..!

Hi,

i have a problem. I don't know to set digicheck.

I use a macpro (10.5.8) with a fireface 800 (driver 2.62) and LOGIC (9.0.2).

There isn't signal into digichek, if logic play a project or itunes a mp3.

How can i route my monitor signal  (an1 - an2) into Digicheck?

Thanks.





edg

  • From: Israel
  • Registered: 2009-11-10
  • Posts: 5

Re: Digicheck 0.61: help..!

Hello edg,
after u've clicked on DC look at the menu bar you'll have the Options menu, there you have Input Device Setup or simply press F3
now can choose - input or output, in case you wanna see your output choose Hardware, then playback or output.


My problem with Digicheck is that the Hardware select is Disabled on Spectral Analyzer, Vector Audio Scope, Totalyser...I have only CoreAudio option Available and i can choose only Input to see..
im using OSX 10.5.8 with FF400 and logic 9
its quite annoying that i cant get the most out of this proggie...
please advice..

Thanks in advance.

phORce.

ph0Rce's Website

  • From: Israel
  • Registered: 2009-11-10
  • Posts: 5

Re: Digicheck 0.61: help..!

Any ideas someone?...anyone? HeadScratch

ph0Rce's Website

  • Jeff
  • Jeff
  • Moderator
  • Offline
  • From: USA
  • Registered: 2007-05-21
  • Posts: 4,619

Re: Digicheck 0.61: help..!

You need to use the internal loopback capability of the Fireface Mixer with these functions. It's described in the manual, and explained many times in this forum already.

Regards,
Jeff Petersen
Synthax Inc.

Jeff's Website

  • From: Israel
  • Registered: 2009-11-10
  • Posts: 5

Re: Digicheck 0.61: help..!

Thanks Jeff, ill check it out.:-)

ph0Rce's Website