• Attex
  • New member
  • Offline
  • Registered: 2007-05-14
  • Posts: 5

Topic: 9632 not being seen by Computer

I have a older DSP 9632.  I just made some upgrades to the system that I'm running the card on: Memory, video card, Ethernet card and printer. I reinstalled the 9632 and now the system does not detect it. Could the addition of the Ethernet Card, Video Card and Printer have robbed resource required for the 9632?

Thanks
Joe

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,669

Re: 9632 not being seen by Computer

Usually not. I would expect contact problems or that Windows had disabled the card (see Device Manager).

Regards
Matthias Carstens
RME

MC's Website

  • Attex
  • New member
  • Offline
  • Registered: 2007-05-14
  • Posts: 5

Re: 9632 not being seen by Computer

MC wrote:

Usually not. I would expect contact problems or that Windows had disabled the card (see Device Manager).

Not showing in the Device Manager.

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,669

Re: 9632 not being seen by Computer

You can try the blue jumper (see manual page 8).

Regards
Matthias Carstens
RME

MC's Website

  • Attex
  • New member
  • Offline
  • Registered: 2007-05-14
  • Posts: 5

Re: 9632 not being seen by Computer

MC wrote:

You can try the blue jumper (see manual page 8).

Pulled the blue jumper...  That did the trick!!!  The up grades of the two cards to my system must of affected the voltage at start up.  I guess my system is the first for this problem?
Thanks for the help!

Joe