1 Topic by zendrum (edited by zendrum 2010-09-02 19:51:40)

  • Registered: 2010-06-11
  • Posts: 23

Topic: MADI Daisy-Chaining

I read up on MADI daisy chaining here in the various forum posts and in the RME manuals, but I still have one question.  Can you daisy chain modules from different manufacturers?  I assume you can, but I'd like to be sure.  Would this setup work, and if so, how would the various I/O points appear in my DAW?

SSL XLogic Alpha-Link MADi SX   ----->   RME Micstasy + I 64 MADI Card   ----->  HDSPe MADI
                |                                                                                                      |
                <---------------------------------------<---------------------------------------<

Thanks!
zendrum

  • Jeff
  • Jeff
  • Moderator
  • Offline
  • From: USA
  • Registered: 2007-05-21
  • Posts: 4,674

Re: MADI Daisy-Chaining

Yes, you can do this, as long as you have a bank of 8 channels unused by the Alphalink. You'll set the ID# on the Micstasy to make sure it uses these open channels. For instance, ID#1 is ch 1-8, ID#2 is ch 9-16, etc.

You will lose MIDI over MADI control of the Micstasy, since the SSL unit will not pass this data.

Regards,
Jeff Petersen
Synthax Inc.

Jeff's Website