• From: Houston, TX
  • Registered: 2007-05-11
  • Posts: 1,191

Topic: ADI-8 Pro - Does not "Remember" its settings after power-down?

I have an ADI-8 Pro and a Nuendo 8 I/O (both are 48K Units that I purchased used on eBay for a steal wink ), and neither of them remember the clock/level settings on the front panel when I remove power.  I have to re-set both units to "Hi-Gain/Low-Gain", and adjust clocking accordingly on power-up.

I looked for a button-cell "memory backup" batery inside the units, but I didn't see any.  Is this normal behavior?  Is there a way to avoid this besides leaving the units powered on 24/7?

Thanks

cool

MADIface-XT+ARC / 3x HDSP MADI / ADI648
2x SSL Alphalink MADI AX
2x Multiface / 2x Digiface /2x ADI8

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,670

Re: ADI-8 Pro - Does not "Remember" its settings after power-down?

Only the latest generation of the Pro remembers its state. And there is no way to change this, sorry.

Regards
Matthias Carstens
RME

MC's Website

  • From: Houston, TX
  • Registered: 2007-05-11
  • Posts: 1,191

Re: ADI-8 Pro - Does not "Remember" its settings after power-down?

Thanks for the info smile

MADIface-XT+ARC / 3x HDSP MADI / ADI648
2x SSL Alphalink MADI AX
2x Multiface / 2x Digiface /2x ADI8