• Registered: 2008-01-01
  • Posts: 3,025

Topic: Basic Signal Generators in DIGICheck?

Ahoi!

I still would like to see some basic signal generators in DIGICheck, like test-tone, sweep and white/pink noise.

Is there any chance of getting these in a foreseeable future? wink

  • Registered: 2007-05-01
  • Posts: 128

Re: Basic Signal Generators in DIGICheck?

+1

That would be very useful.

Regards,

    b.

https://granurise.com
  • From: Houston, TX
  • Registered: 2007-05-11
  • Posts: 1,191

Re: Basic Signal Generators in DIGICheck?

+2.  If it could also allow sending standard reference levels on RME Analog Connections - that would be even better (like 1KHz at .775v RMS, 440Hz @ +4dBu, etc)!  Granted, the RME unit would need to be known (FF800, Multiface, etc) and have to be set to a known level (High-Gain, etc) for this reference level to be accurate - it would still be a nice feature (or maybe add a selectable reference level setting so the software knows the current hardware level). 

Perfect for DIY gear calibration and such (two Hairball 1176 rev A's on their way to me! :-) ).

cool

MADIface-XT+ARC / 3x HDSP MADI / ADI648
2x SSL Alphalink MADI AX
2x Multiface / 2x Digiface /2x ADI8